Choose the most appropriate drive for the job

Electronic servo drives are certainly in vogue. For many design engineers, they are the preferred choice for systems which synchronise and co-ordinate the movement and position of fast moving components. Clearly they have an important contribution to make but they are not necessarily the right choice for all applications.

A mechanical solution may not be as technically exciting but in many cases it can be more reliable, more accurate and far more cost efficient in the long run.

Mechanical drives are often seen as old fashioned and low tech.

In truth they are the subject of much development.

The fact is mechanical drives are increasingly getting better and those at the quality end of the scale are now able to deliver even greater accuracy and reliability.

More accurate machining of components, more durable materials, higher quality bearings, new methods of heat treatment, and heating which effectively eliminates any distortion - all these elements have contributed to the significant improvement.

The electronic drive is often sold on the basis of it being more accurate than its mechanical counterpart.

Certainly mediocre quality mechanical drives may be inferior but those at the higher end of the quality scale can far exceed the accuracy of the electronic drive.

The main benefit of a largely mechanical system - one comprising line shafts and bevel gear boxes - is that its accuracy is maintained throughout the system.

Basically, what you put in at one end, you get out the other! Within one revolution a mechanical drive will always repeat itself, it will always return to its original position.

Of course the transmission error of a geared system must be considered, but this can be measured.

It is a known quantity for which compensation can be made if necessary.

In a multi-stage process driven by electronic drives, the relationship between the position of the product and various elements of the machine is fed back to the controller by a variety of peripheral sensors.

The system is therefore far more complicated and often servo motors cannot respond fast enough to achieve the required degree of accuracy.

By its very nature, an electronic drive system will only respond to where the product was in relation to the drive, not where it is.

There are however, applications where a single electronic drive offers advantages over a single mechanical drive.

If you need fast response and where the application involves changes in motion, the electronic drive is the best choice.

It is ideal for replacing cams and for applications which require high torque for fast acceleration and braking.

However, if the whole system requires high torque, the electronic drive and motor will need to be large and may be very expensive.

In this case a motor/gearbox solution will produce high torque far more cost-effectively.

Electronic drives are also limited when it comes to providing high torque at low speed; gearbox speed reduction is the only viable solution.

Electronic drives are often chosen for machines used to produce or process a number of different products.

Stored set-up data can be quickly called-up to re-set the machine with changed parameters.

But an electronic drive does not always have to be the foregone conclusion.

Speed modulation gearboxes are increasingly being used in packaging machines and in particular cartoning machines.

These gearboxes allow adjustments to be made in machine set-up to accommodate different carton sizes at a much lower cost than having all components being driven and controlled electronically.

Notably, the speed modulation gearbox offers considerable benefit over traditional systems comprising gearboxes, line shafts and chains.

Adjusting such a mechanical system would take upwards of 45 minutes.

Systems using speed modulation gearboxes, with a manual adjustment, may take just two minutes to set up.

Although the cost of servo drives is certainly reducing, they remain expensive in relation to mechanical drives.

One of the main cost penalties is the programming back-up they require.

In fairness, the majority of good servo drive manufacturers do offer this service but help is not always readily at hand in the middle of the night shift! Also when problems occur in an electronically driven system it can be difficult to know where to start.

A largely mechanical system is much more simple and user-friendly.

A problem is easier to track down.